[arm-allstar] Second USB Rim-LIte Causes the new one to not pass audio.

[ARM Allstar]

Interesting!  I went ahead and ordered a powered USB hub, should be here on
Wednesday.  I'll test that out and see if it makes a difference.

WG5EEK

On Mon, Nov 9, 2020 at 6:34 PM "ARM Allstar via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> *I had a similar issue just last night when adding a second U.R.I. to a
> Pi 3b+. When using menu item "D" the tone from the second U.R.I. was
> quite broken, jittery, and distorted sounding but when using a hand mic
> on the repeater TX radio it sounded fine. After a complete reboot,
> things seemed to calm down. I'll be revisiting that one again later
> tomorrow.
>
> N5ZUA
> *
> On 11/9/2020 1:19 PM, "ARM Allstar via ARM-allstar" wrote:
> > Mike,
> >
> > Using two USB fobs on an RPi3B should work fine, I've got many setup this
> > way.  Did you use the simpleusb-tune-menu program to setup the fobs?
> >
> > The procedure is to plug in only the first fob, select the proper
> > simpleusb device (menu option 's'), perform setup and save (menu option
> > 'w'). Then, plug in the second fob as well (both now plugged in), select
> > the second simpleusb device (menu option 's'), perform setup and save.
> > Exit out of the simpleusb-tune-menu program and restart....The fobs
> should
> > both now be happy.
> >
> > 73, David KB4FXC
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>