[arm-allstar] Second USB Rim-LIte Causes the new one to not pass audio.

[ARM Allstar]

*I had a similar issue just last night when adding a second U.R.I. to a 
Pi 3b+. When using menu item "D" the tone from the second U.R.I. was 
quite broken, jittery, and distorted sounding but when using a hand mic 
on the repeater TX radio it sounded fine. After a complete reboot, 
things seemed to calm down. I'll be revisiting that one again later 
tomorrow.

N5ZUA
*
On 11/9/2020 1:19 PM, "ARM Allstar via ARM-allstar" wrote:
> Mike,
>
> Using two USB fobs on an RPi3B should work fine, I've got many setup this
> way.  Did you use the simpleusb-tune-menu program to setup the fobs?
>
> The procedure is to plug in only the first fob, select the proper
> simpleusb device (menu option 's'), perform setup and save (menu option
> 'w'). Then, plug in the second fob as well (both now plugged in), select
> the second simpleusb device (menu option 's'), perform setup and save.
> Exit out of the simpleusb-tune-menu program and restart....The fobs should
> both now be happy.
>
> 73, David KB4FXC