[arm-allstar] Repeater Bounce, ping-pong

[Doug Crompton]

This is most always caused by both ends automatically sending something to
the other. So think of it this way - if you connect your simplex node to a
repeater and you key up the repeater responds back. That is what it should
do. Then your end sends a courtesy tone back automatically which most
simplex nodes do and the cycle starts back and forth. The only answer is to
turn off the courtesy tone at the simplex end. The simplex end should send
nothing back in response to a keyup. In rpt.conf -

nounkeyct=1

and restart asterisk.

this defaults to =0 in the distribution.

*73 Doug, WA3DSP*
*http://wa3dsp.org <http://wa3dsp.org>*

On Mon, May 4, 2020 at 7:55 PM "R I via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I finally got this CDM radio working. My DTMF instructions still aren't
> working but my mail problem now is this.
> I can DTMF from Supermon into the repeater no problem. When I connect via
> Echolink to another repeater the Ptt bounces back and forth non stop. Both
> my machine and there have no tone and a short tail.
> I have played with with the simple USB RXonDelays and all but can not stop
> it.
>
> Any ideas?
> KB2URT Raul
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>