[arm-allstar] allstar node with hamvoip stopped reading cos correctly

[Rick Dykstra]

If you're using and SD card, it's possible a file was corrupted during 
the write. I've seen this twice now on a couple of my nodes when 
updating rpt.conf.  I renamed the file and copied a back up version, and 
restarted asterisk. Problem was solved.


Rick - KR8T

On 3/27/2020 4:15 PM, "ku6v via ARM-allstar" wrote:
> On node 46533 I checked for an update 4 days or so ago. The node was
> connected and working fine before the next chain of events described below
> this.
>
> After the attempt to do so the node went into a mode that only sees COS
> present and that then locks up in TX.
>
> I have reset the power with a web power switch on the mountain remote site.
> No change.
>
> I have disconnected the URI interface and isolated the node from the RLC4
> that connects all the RF radios and repeaters to the node. This leaves the
> node 46533 isolated from the RLC4 and all the other hardware logic inputs
> that would influence the node input logic gates.
>
> I then attempted to reload or check for an update that might clear the issue
> that appeared after the attempt to check for update, item 1, on the admin
> console. However, no new update was available.
>
> Can I force and update OR should I simply start over and reload the Hamvoip
> software?
>
> Any and all input is appreciated.
>
> Wishing to all you are staying safe and healthy as we all go forward.
>
>   
>
> 73 de KU6V
>
> Don
>
>   
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org