[arm-allstar] eth0 & wlan0

[Peter Paul Fox]

Hi all,

I have an odd problem which has appeared. When I have the ethernet cable plugged into the RPi I can SSH into it using either the eth0 IP or the wlan0 IP value (both different) When I remove the ethernet cable I cannot SSH into wlan0
I put the cable back in and SSH into Allstar. And at the top of the menu it says;
Admin Menu List for RPI  (192.168.xx.29, 192.168.xx.22) and restarted the Asterick Server I get
Automatically restarting Asterisk          Restart Asterisk Server          ended with exit status 1
Asterisk died with code1.

Using Supermon I try to connect to a local Node but it attempts and quits without any message.

Running CLI I get

WARNING[26810]: chan_iax2.c:7844 registry_rerequest: Received unsolicited registry authenticate request from '192.83.199.4'

When I run ifconfig I get this and I notice ‘Ethernet’ is in both eth0 and wlan0
192.168.xx.255 is not my gateway.

eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.xx.29  netmask 255.255.255.0  broadcast 192.168.xx.255
        ether b8:27:eb:c0:20:1e  txqueuelen 1000  (Ethernet)
        RX packets 5919616  bytes 301440965 (287.4 MiB)
        RX errors 0  dropped 2851  overruns 0  frame 0
        TX packets 645355  bytes 59791574 (57.0 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 1190591  bytes 95612400 (91.1 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 1190591  bytes 95612400 (91.1 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.xx.22  netmask 255.255.255.0  broadcast 192.168.xx.255
        ether 00:36:00:00:f7:d2  txqueuelen 1000  (Ethernet)
        RX packets 6391903  bytes 431486329 (411.4 MiB)
        RX errors 0  dropped 361674  overruns 0  frame 0
        TX packets 18637  bytes 1161330 (1.1 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0

There must be an error in a config file but my knowledge of Linux works if I can do the correct search, but not managed to find the route. I know I can rebuild from scratch easily but sometimes I like to find the problem in case it occurs again.

Peter Paul Fox G8HAV
5 Llandovery Close
WINSFORD CW7 1NA
Tel: +447919315547

Dane Valley RAYNET
Midcars.org