[arm-allstar] Using Putty Problems at the Start

[stanley stanukinos]

Can you get into it with a monitor and keyboard? If so did you do an update? Did you also change the port to 222 from 22?

Stan

Sent from my iPhone

> On Oct 20, 2019, at 1:29 AM, Jeffrey Reid via ARM-allstar <arm-allstar at hamvoip.org> wrote:
> 
> Okay, this shouldn’t be that difficult, even for an OM that’s not computer savvy.  Did a clean write onto the SD card.  Checksum okay. Installed into Pi4.  Turn on and blinks dit-dit-dit-dah…The letter V I believe.  I try Putty and know that the ethernet IP connected to the Pi is .106 because I have another node (one of Mark’s nano-nodes).  Use port 222.  Keep getting connection timed out.  So I am stuck at the easy part…Jeez, what am I doing wrong.  I tried typing the IP into the Browser with no luck in getting a page that says TEST.  
> 
> The same cable is now back connected to my other node and working just fine, listening to the Insomniac Net.  Now, if I can only get to configure the new Pi4.  Any Ideas?
> 
> Regards,
> 
> Jeffrey
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org