[arm-allstar] Help with Motorola GM300 CTCSS

[Rachid Karroo]

Doug, in fact I am using this facility to program the GM300. It works fine.
Thank you for adding this option on your website.

73's

Rachid


On Thu, May 30, 2019 at 8:44 AM "Doug Crompton via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Rachid,
>
>   I am not sure where you stand on programming the gm300. I just wanted you
> to be aware you can program it using the Pi as per the howto at
> hamvoip.org
>
> But you must use only an FTDI USB to serial interface as specified in the
> howto with the Motorola programming cable.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
>
> On Wed, May 29, 2019 at 2:17 PM "Rachid Karroo via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
> > Good day to everyone
> > I am running the USB MAXTRACK FOB and have connected it to a Motorola
> > GM300.
> > I have no issues with the COS. The only problem is with regard to CTCSS.
> > Our local repeater system uses CTCSS 97.4 Hz and it seems the GM300 is
> not
> > initiating the required CTCSS in order to go in.
> > Any help would be appreciated.
> > I apologize if this email should not be sent here. If so then kindly
> > contact me directly.
> >
> > Thank you
> > 73's
> >
> > Rachid
> > 3B8FP
> > Node: 40248
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>