[arm-allstar] USBRadio - Save Settings

[David McGough]

Hi Brad,


I haven't run usbradio in a while, but I'll try to help.

The problem is that you're not able to get enough discriminator noise for 
usbradio to configure properly. What type radio are you connecting to? Are 
you connected to the discriminator audio output?

The usbradio driver may have issues with some newer sound fobs---what type 
of fob are you using??

Also, you can perform usbradio setup directly from the Asterisk CLI. For 
example:

hamvoip-kb4fxc*CLI> radio active 
Active (command) USB Radio device is [usb1798]
hamvoip-kb4fxc*CLI> radio tune save
Saved radio tuning settings to usbradio_tune_usb1798.conf

...Check out all the "radio" commands available in the CLI.

The logs related to pacman updates are in the file: /var/log/pacman.log  
Note that /var/log is a temporary filesystem --- it gets erased whenever 
you reboot.

73, David KB4FXC


On Mon, 27 May 2019, "Brad Trogdon via ARM-allstar" wrote:

> Have two questions but main one is around USBRadio Tune Menu.  When
> selecting 2) Auto-Detect Rx Noise Level Value (with no carrier) the option
> works and sets the correct value until another menu selection is made or
> until AllStar restarts.
> 
> Here is the returning message that says ERROR: RX INPUT ADJUST FAILED.
> <Full Snip-It below>
> 
> I am using the latest version of HamVoIp.
> 
> A. Where should the settings be saved? or where can I find the setting that
> is temporarily applied?
> B. Should their be an entry in /etc/asterisk/usbradio_tune_usb23702 for
> sqnoise or something similar to set and maintain the value?
> C.Last question is I updated via the Admin Menu List by selecting 1 Perform
> a system UPDATE.  Through the process I observed errors but they scrolled
> by so fast could not comprehend them.  Where can I find a log or view the
> errors that presented during the update?
> 
> <Snip-It>
> Please enter your selection now: 2
> tune rxnoise maxtries=12, target=27000, tolerance=2750
> tries=0, setting=2, meas=65
> tries=1, setting=16, meas=786
> tries=2, setting=16, meas=734
> tries=3, setting=16, meas=9349
> tries=4, setting=16, meas=5417
> tries=5, setting=16, meas=25529
> tries=6, setting=16, meas=710
> tries=7, setting=16, meas=667
> tries=8, setting=16, meas=672
> tries=9, setting=16, meas=674
> tries=10, setting=16, meas=780
> tries=11, setting=16, meas=687
> DONE tries=12, setting=1000, meas=687, sqnoise=114
> ERROR: RX INPUT ADJUST FAILED.
> 
> I have searched the archives with negative results.  As always thank you to
> the HamVoIp community for your assistance.
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>