[arm-allstar] Internal & External Nodes with DTMF routing with Echolink

[Kyle Krieg]

We are in the final stages of deploying a private and external AllStar
network at our repeater system, but have some last min questions regarding
configurations.

We have a Fusion repeater, 146.850 that is connected to a CAT800
controller.  This CAT800 controller will be connected to private AllStar
node 1085 running HamVoIP.  1085 will have internet access for updates and
getting into the supermon page from the internet.

In the future, we will have other repeaters on our private 192.168.x.x
wireless point to point network that we will connect to internal private
AllStar nodes.  1097, 1091, 1007, etc....

Setting on the same 192.168.x.x network as the 1085 node is node 40105 with
no radio/URI connected.  40105 will also have internet access and can be
accessed by anyone.  40105 will serve as our "gateway" node facing the
outside world.  Node 40105 will be connected to the 1085 full time.  Node
40105 will also run Echolink full time to allow anybody coming in access to
the 146.850 repeater.

Question : Because node 1085 which is connected to a CAT800 and has access
to the RF network, and 1085 is connected to 40105 full time, if I wanted to
come in via RF and connect externally into an Echolink node, how do I pass
DTMF tones from the via RF through the CAT800, into the 1085 node directly
then into the 40105 node but not have the 1085 node respond to those DTMF
tones so 40105 which runs Echolink responds to those commands????

Whew.!!!!!

Kyle
AA0Z