[arm-allstar] Controller Connections

[Mike Sullivan]

Repeater Builder makes the RIM Lite, one version specifically for the
RC210. We use it, had a couple quirks at first that ended up being a bad
USB cable, and have had no problems since. Everyone else recommends the
DMK-URI if you want to spend a bit more money.

You can run Echolink from the same node, however the Hamvoip image doesn’t
support Echolink Proxy, so keep that in mind.

Mike

On Sat, Jul 13, 2019 at 16:36 "K6ECS Allstar via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Our small Dell GX520’s both failed and maybe just need power supplies.
> Doesn’t matter. Time to move to PI 3a’s and get with the real world! We’ll
> still need a Windows computer for accessing the controller settings as
> needed.
>
> At any rate, how simple is it to wire into an Arcom controller? Just PTT,
> Ground, RX audio and TX audio? Or does it need to go through an RTCM, which
> we have. Should I connect one PI to a Link Channel as Allstar and a second
> for IRLP/EchoLink?
>
> We first need to find the foolproof method of attaching the Arcom to a
> wonderful MSF 5000 that had a Zetron controller connected and my brilliant
> Elmer just cut the connections off without noting the wire. He skipped town
> after first swapping parts from another MSF that he was to “inspect.” I get
> to start over.
>
> Thank you in advance.
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org