[arm-allstar] UV-82 No audio/DTMF input

[James WD0JB]

I believe I never followed up when I was having a similar issue. The
problem I was having was in the simple usb conf file, I had the ctcss set
to usb instead of off. Might just double-check that setting.

73

James WD0JB

On Tue, Jul 9, 2019 at 01:08 "Dave Perkins via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hi,
>
> I put together an Allstar node using an RPi3, UV-82, and an RA-40
> sound fob....Did the mod to the UV82 using the Hamvoip article.
>
> All came together just fine. However, I am not getting any audio
> input or DTMF to the UV82. Even when using the CLI client, nothing
> shows. I can manually connect to a node using rpt fun <mynode> *32560
> Radio will connect and I can hear stations talking just fine. I key
> down to transmit and I can see the UV82 receiving my signal, but it
> is not going out. When I use simple_tune on option 2 (RX level
> adjust) I see normal deviation when I talk. It is currently set to
> 400 and the levels are fine and within the scale between the 3-5 range..
>
> 4.7K resistors installed on RX and TX. 10K on COS as well as the FET.
>
> I've checked my wiring three (3) times now and can't figure out what
> is going on. I saw another person on this list had the same problem
> but never saw if his issue was solved.
>
> Thanks
> Dave
> KC6ZBE
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
-- 
73,

James WD0JB