[arm-allstar] Interfacing URIx with Zetron ZR310 controller

[Doug Crompton]

Brad,

 I assume your problem is COS to the FOB.  There is no ppinvert. The Pi has
no parallel port. All audio and control lines are via the USB FOB. -  the
options in simpleusb-tune-menu item J are usb or usbinvert.  If you are
using a DMK/URI it is pin 8. You need to determine the level coming from
the controller when you have a receive signal. If it goes low on signal
then you would use usbinvert. If it goes high you would use usb.  The low
level needs to be 0 volts or close to it and the high can be anything above
2 volts or so.

You can use the V option in simpleusb-tune-menu to realtime view the COS
INPUT line.  It will show keyed or clear depending on the state.  If COS is
not keyed you will have no audio into Allstar (RX audio). If COS is hung
keyed you will have no audio out of Allstar (TX audio) until it clears.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*



On Sat, Jan 12, 2019 at 12:28 AM "Brad Trogdon via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Anyone connected AllStar directly to a repeater via the Accessory connector
> on the ZR310 by chance?
>
> I have this working AllStar > repeater Audio
>
> Issue is Repeater audio > AllStar.   Some audio when set to ppinvert but
> times out because COS (all three in display) are keyed constantly.
>
> Thoughts?
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>