[arm-allstar] Allstar setup template error

[James Hause]

Hi Doug,
Well I have set up a couple nodes recently, and have done the firsttime.sh
on both a couple days ago, not sure what days exactly.
I looked at my rpt.conf files, and I have gotten myself confused.  There is
some stuff in what looks to be the 2 node number that has
me confused in regards to what your talking about.  Any rate, could I send
you an email with my rpt.conf file for you to look at?
I think all is ok, but not sure.
Jim, KF5LBT

On Thu, Feb 21, 2019 at 1:00 AM "Doug Crompton via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> It has come to our attention that there was an error in the rpt.conf
> template that has now been corrected in an update but some of you who
> started up new servers in the last week or so may have an error in your
> rpt.conf file.  This only applies to NEW servers that were put online
> (initially setup) after the Feb 11 update using the firsttime or node_setup
> scripts. This probably only applies to a small number of people but if you
> recently put a server online please check it. Since the rpt.conf file is a
> protected file once it is created from the template we do not overwrite it
> so if you think you are in this category check your /etc/asterisk/rpt.conf
> file for the following line in the first stanza. The one where your first
> node is defined. Here is what to look for -
>
> telemetry=telemetry
> OR
> telemetry=telemetryXXXXX       - where XXXXX is your first node number
>
> Note if this line has your node number after the second telemetry. Then go
> down to the actual telemetry stanza further down in the file. It will look
> like this -
>
> [telemetry]
> OR
> [telemetryXXXXX]       - where XXXXX is your first node number
>
> The key here is that the RIGHT side of the telemetry=telemetry must be the
> SAME as the name in the telemetry stanza. It will either have your node
> after it or not. It does not matter which as long a BOTH match.
>
> EXAMPLE -
>
> if in the node stanza is  telemetry=telemetry   then  the telemetry stanza
> would be [telemetry]
>
> if in the node stanza - telemetry=telemetryXXXXX  then the telemetry stanza
> would be [telemetryXXXXX]
> where XXXXX is your first node number.
>
> In other words they MUST match.
>
> If you update your node you will have this fix in your template but it will
> NOT fix the problem if it should exist in your real rpt.conf file from
> running a setup since Feb 11, if you did that update. If you download the
> image you should always perform the update as the first question in the
> setup to ensure you have the latest code before you setup your node.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>