[arm-allstar] AllStar VoIP gain

[Yoram Rotbach]

Thanks Doug,

Haven’t received to first email

73
Yoram 4Z1YR

נשלח מה-iPad שלי

> ‫ב-11 בדצמ׳ 2019, בשעה 8:34, ‏‏Doug Crompton via ARM-allstar ‏<arm-allstar at hamvoip.org> כתב/ה:‬
> 
> Repeat of previous reply....
> 
> Yoram,
> 
> The proper way to set levels is to first set item 2 - RX level. You should
> look at this with many users as some may be out of spec. It should peak in
> the 5-6khz range on the bargraph. Then set item 3 TX level. This should be
> set with a service monitor looking at the output of the repeater but since
> many do not have one you can audibly check the level against some other
> known source. Input and output levels of the repeater switching between
> input and output should have the same level.
> 
> 
> *73 Doug*
> 
> *WA3DSP*
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
> 
>> On Wed, Dec 11, 2019 at 1:06 AM "Yoram Rotbach via ARM-allstar" <
>> arm-allstar at hamvoip.org> wrote:
>> 
>> Hi
>> I’ve connected 4 AllStar repeaters to a central radioless node.
>> I’m getting complaints from the repeaters users that while local repeater
>> audio levels are fine, audio levels coming from other repeaters are lower.
>> Is there a parameter that allows putting more gain on audio coming to the
>> repeater from the network?
>> 
>>    Thanks and 73
>>    Yoram 4Z1YR
>> _______________________________________________
>> 
>> ARM-allstar mailing list
>> ARM-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> 
>> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>> 
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org