[arm-allstar] Allstar RF Link

[Doug Crompton]

Jerry,

 If you have control over the repeater the way to do this is to have the
repeater PL output follow the repeater PL input thus no tail or repeater
messages or courtesy tone would make it to the remote node which would be
looking for the PL. On some controllers this is easy to do and on others
you would have to actually make modifications. BTW this is not a dumb
question many have this issue as they do not have Internet at a repeater
site and need to use a remote node. The downside of course is that it is
then not full duplex.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Wed, Aug 28, 2019 at 9:07 PM "Jerry Swords via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I am sure this is a dumb question but I have hamvoip running on a PI 3 and
> a URI interface to a mobile radio that I RF link to a local repeater, the
> repeater has a controller connected to it , is there a way I can keep the
> repeater ID from being transmitted out to the node, the repeater dose use a
> PL of 114.8 on RX & TX ? the repeater controller is a Scom 7330
>
> [https://ipmcdn.avast.com/images/icons/icon-envelope-tick-green-avg-v1.png
> ]<
> http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
> Virus-free. www.avg.com<
> http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>