[arm-allstar] radioless node dtmf problem

[David McGough]

Forwarded message
----------------------------------------------------------------------

Date: Mon, 22 Apr 2019 10:26:32 -0700
From: Larry <larry at thunderbolt.net>
To: Alan Matthews via ARM-allstar <arm-allstar at hamvoip.org>
Subject: Re: [arm-allstar] radioless node dtmf problem


Alan ...

The lock and/or  DTMF switches on the mic itself could be an issue.

If you wired 5 volts to pin 5 of the mic connector when the Lock is set to 
OFF the mic lighting should illuminate. If not DTMF will not be powered.
Make sure the DTMF button is NOT in the disable position.

Also believe it or not some folks not use to using a DTMF mic assume that 
dialing the numbers will automatically key the node. Not so you must hold 
PTT button
while dialing.

Larry - N7FM


On Mon, 22 Apr 2019, "Alan Matthews via ARM-allstar" wrote:

> hi group
> 
> I have made a radioless node and it works fine. However I am using an alinco EMS-57 dtmf mike powered by 5 volts from the usb, I am not sending any dtmf tones. Is there a setting in the software that needs adjusting?, or am i overlooking something. I assume this mike should work with dtmf for the radioless node.
> 
> any help would be appreciated.
> 
> regards Alan
> 
> ---
> This email has been checked for viruses by AVG.
> https://www.avg.com
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>