[arm-allstar] Using a FT-2500M as a simplex node radio

[Russell Thomas]

great, thanks Doug.
where can i get a fob for the PI to wire up a connector for the mic jack?



On Sat, Apr 6, 2019 at 6:37 PM "Doug Crompton via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Russ,
>
>  Refer to the manual page 44, 45  -
>
> This isn't the best manual download. If you don't have a manual you can use
> this link or find a better one -
>
> http://www.iw2nmx.it/Yaesu/FT-2500M/FT-2500M%20Instruction%20Manual.pdf
>
> There apparently is an internal jumper to give COS on pin 1 of the mic
> jack. Doing that you would have everything you need on the mic jack
> including RX audio.
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
>
>
> On Sat, Apr 6, 2019 at 7:29 PM "Russell Thomas via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
> > I have a Yaesu FT-2500M sitting around not doing nothing. I also have a
> 2 m
> > all directional antenna about 45 ft in the air.
> > I was thinking about putting both to good use again in the form of an
> > All-Star simplex node.
> > The manual shows the pins for the microphone and in the past I have
> built a
> > tnc for APRS for it.
> > What would it take to interface this radio to a PI with the Ham VOIP
> image?
> >
> > 73,
> > Russell Thomas, KV4S
> > DMR TG: 240218 | YSF: US KV4S | D-STAR: XRF334R
> > Allstar: 47923 | IRLP: 4535 | EchoLink: KV4S-L
> > Web: http://KV4S.com
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>