[arm-allstar] TX Audio adjustment

[Doug Crompton]

Chuck,

   The TX audio (audio from your node to the radio you are talking on) is
controlled by item 3 in simpleusb-tune-menu. This is item 12 from the main
menu. Values range from 1 to 999.  Try turning it down in 50 point steps.
The audio level you hear should be the same as that which you would hear
from a local repeater and of course it should not be distorted. One
possibility is that the RA35 is over driving you radio. You may need to put
a resistive divider on the audio output of the RA35 before it reaches your
radio. A 10K resistor in series with a 10K to ground on the radio side
would cut it in half. If you need more reduction reduce the 10K to ground.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Tue, Sep 11, 2018 at 1:25 PM "Chuck Kendrick via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> HelloIs there anyone that could help me with an audio adjustment problem
> on  my all-star node.My node set up is a Yaesu FT-7800 with a RA-35
> interface.MY audio in to the system is good , but my TX audio is coming out
> a little too loud with a slight distortion.I am unfamiliar with Linux, so I
> need to be instructed on how to get into it, and how to adjust it.
> 73
> Chuck KendrickKD6DWX
>
>
>
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org