[arm-allstar] IDing of Simplex node not working

[Doug Crompton]

Arthur,

  Did you setup your node using the hamvoip setup? Also the first thing you
need to check are your levels using simpleusb-tune-menu - item 12 on the
main menu. Item 2 on the simpleusb menu sets the level coming from your
node radio. It is important that it is set to 5khz on voice peaks. Then use
item 11 Asterisk client on the main menu to see if all your DTMF codes are
decoding properly. They will appear on the screen as you press them if they
are decoding.

The ID is part of the setup. You have a choice of CW or voice ID. Perhaps
you need to run setup again to resolve some of these problems. For a full
run of setup go to the Linux prompt - item 9 on the menu and  type
firsttime.sh

You can manually change the ID by editing the rpt.conf file but this should
not be necessary if you run the setup.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Thu, Oct 25, 2018 at 1:32 PM "Arthur Putnam via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> I am unable to get my simplex node to ID. Is there detail instructions on
> How To do this?
> Also only a few DTMF codes seem to work. Connect and Disconnect work fine,
> but 80 and 81 do not. Etc... where is instructions for DTMF found?
> Thank YouN7MNKART
>
> Sent from Yahoo Mail on Android
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>