[arm-allstar] The Quantar and AllStar

[Tim Sawyer]

Yes, that doable. I run mix-mode Quantar with AllStar. You have to use P/L
or DPL on analog. Then in the wildcard tables set the P/L output pin to be
P/L not RxQuality.  That works because P25 will have not PL but RX quality
is met with a good P25 signal.

P. S. Those wildcard names aren't exact as I don't have a codeplug in front
of me.

On Tue, Oct 23, 2018 at 1:03 PM "William Freeman via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Quick question for the brain trust, but will provide a little background to
> make answers and possible brainstorming easier.
>
> We are currently running a mixed-mode P25/analog Quantar. The analog side
> is currently linked in on AllStar. We would like to ultimately link the P25
> into the AllStar side via the URI and Pi, but have not found a way to do
> that (every time I've asked the question, I always get suggestions on how
> to link to P25NX, but not AllStar which all that we are interested in).
>
> Now for the question: Is there a way to modify the routing tables to
> prevent the Quantar from telling the URI/Pi that the repeater is keyed when
> in P25 mode ONLY? When users are using P25, the AllStar has a dead carrier
> key-up (which goes out over the network to other repeaters) while the P25
> user is keyed-up. Once the user finishes transmitting, the Pi sends the
> courtesy tone indicating that someone was using the repeater locally.
>
> Thanks in advance for the suggestions.
>
> Bill N4NJJ
> --
> William Freeman
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>


-- 
Tim WD6AWP