[arm-allstar] Node txing without the radios

[Doug Crompton]

But that does not make sense. You do want the iax port you are using
(default 4569) to be open otherwise Allstar will not work.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Wed, Oct 17, 2018 at 9:15 PM "Kerry McKenzie via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hi all
> By chance I was re reading the docs again on the web site and I looked
> closely at the firewall instructions.
> My node has been running 12 months now and in the very beginning I tried to
> setup iax but had no joy in getting it to work.
> I discarded any further attempts and went in to set up echolink instead.
>
> After reading the firewall instructions I went back into my router and
> checked to see what ports I had open, and in the firewall config of my
> router the ports for iax were still open. I had long since forgotten that
> they were open or would have any effect since nothing was working.
> After closing those ports I reconnected to a friends node and waited for
> the 30 minute period to come, nothing happened, and now it has been several
> 30 minute cycles with no interference by me to others that I am connected
> to.
>
> So I’m hoping that the problem is fixed as it is now so obvious but it has
> taken a lot of hair pulling to get to this point.
> I will continue to stay connected and if the issue has gone will repost to
> confirm.
> Thanks to all those that sent me segestions very much appreciated
>
> Regards Kerry VK4TUB
> --
>
> regards Kerry
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org