[arm-allstar] Misbehaving Node

[Doug Crompton]

David,

I presume you have rebooted and have the same results. Are you seeing any
log messages that would be instructive? Anything showing in the client when
you connect?

After two years it certainly would not hurt to put in a new SD card
although there is no real time limit on the card the way we use it.

Is this at a place where it is hard to get to? If not I would just do a
backup using file-backup.sh and copy the backup using scp to another system
and put V1.5 on a new SD, update it and do the setup and then copy over the
files you have changed from the backup.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*




On Tue, Oct 2, 2018 at 11:50 AM "David via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

>
> I have a node x that when it is instructed to connect: connects, does not
> send telemetry, hangs ppt on node x, shows connected, is not hanging ppt on
> system connected to, when instructed to disconnect both the original
> connect and disconnect telemetry play and ptt drops.
> Can I force a reload of the software by downloading 1.5 and then upgrading
> again? Or is the sd card going to revert after boot? Or can I load
> everything from the sd card and see if it's good?
> This node has been in operation for 2 years.  Looking to see if there is
> an alternative to making a new image.
> Thanks David
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org