[arm-allstar] alinco dr-x35t/e uri

[gregory]

i am using the dkm uri, no resistors added.

alinco pin# / uri pin#

cos 1 / 8

rx 4 / 21

gnd 5 / 19

ptt 7 / 1

tx 9 / 22


On 05/03/2018 11:01 AM, "Doug Crompton via arm-allstar" wrote:
> Greg,
>
>  I use Alincos on many nodes and I have never had any audio problems. What
> FOB are you using? Do you have any additional resistive padding in line?
>
>
> *73 Doug*
>
> *WA3DSP*
>
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
>
>
>
> On Thu, May 3, 2018 at 1:29 PM, "gregory via arm-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
>> Hello Everyone,
>>     i changed my radio from a kenwook tm-v71a to an alinco dr-435t/e.
>> the system worked great with the kenwood. after hooking up the alinco
>> cod and ptt works fine but the tx and rx audio is so low i thought it
>> wasnt working. after maxing out the tx rx settings to 900 you can just
>> barely and i mean barely hear the tx and rx audio, it sound clear but
>> the base station radio has to go full blast to hear the audio and then
>> the room has to be perfectly quiet. its hard to hear the audio over the
>> volumes being maxed out everywhere but if i listen carefully i can hear
>> the repeater id clearly. any ideas? i have tx set to 900 rx to 900 with
>> rxboost enabled. also when the radio recieves a transmission the audio
>> is too low for anyone to noticed it, everyone thinks its just a carrier
>> and asterisk doesnt see dtmf as well.
>>
>> Gregory
>>
>>
>> _______________________________________________
>>
>> arm-allstar mailing list
>> arm-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>>
>> Visit the BBB and RPi2/3 web page - http://hamvoip.org
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org