[arm-allstar] alinco dr-x35t/e uri

[Larry]

Gregory,

Where on the Alinco are your audio signals connected?
I use some Alinco's and the DE9 on the rear has ample drive for both RX 
and TX audio.
I do not use discriminator audio however...

Also you might explain about your Sound device ... Modified FOB, URIx or 
PC card ..what device?

Larry - N7FM




On 05/03/2018 10:29 AM, "gregory via arm-allstar" wrote:
> Hello Everyone,
>      i changed my radio from a kenwook tm-v71a to an alinco dr-435t/e.
> the system worked great with the kenwood. after hooking up the alinco
> cod and ptt works fine but the tx and rx audio is so low i thought it
> wasnt working. after maxing out the tx rx settings to 900 you can just
> barely and i mean barely hear the tx and rx audio, it sound clear but
> the base station radio has to go full blast to hear the audio and then
> the room has to be perfectly quiet. its hard to hear the audio over the
> volumes being maxed out everywhere but if i listen carefully i can hear
> the repeater id clearly. any ideas? i have tx set to 900 rx to 900 with
> rxboost enabled. also when the radio recieves a transmission the audio
> is too low for anyone to noticed it, everyone thinks its just a carrier
> and asterisk doesnt see dtmf as well.
>
> Gregory
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org