[arm-allstar] DMK usbradio.conf help

[Doug Crompton]

First of all I am not sure why you are using usbradio? If you are using the
hamvoip code it is setup out of the box for simpleusb. The 7900 has a 6 pin
din with all of the connections necessary to connect to the DMK URI. Page
10 of the manual shows the connections.   Use COSFROM=usb  NOT usbinvert.
Set the levels and you should be good to go. Get rid of all usbradio stuff.
Call simpleusb in rpt.conf as shown in setup config. Use the menu to setup
usb  -  simpleusb-tune-menu

Wire like this -

7900 Din                     DMK URI
----------------------------------------------------------------
   1                                 22         TX audio
   2                                19,20      GND
   3                                   1          PTT
   5                                 21          RX Audio
   6                                   8          COS



*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*






On Fri, Mar 23, 2018 at 7:30 PM, "Del James Beauchamp via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hello all I have several nodes operating one connected to DMK and yaesu
> 7900 operates and plays well other nodes however when the radio receives RF
> nothing is received into the node.  Using usbradio.conf and manually
> configuring.  I am looking for some help with the ctcss/ pl thinking that
> it's not picking up the carrier to signal the DMK interface.  Currently the
> radio is cross banding into a repeater with a 107.2 plWhen any other node
> is transmitting this node picks up and transmits fine with the tone and
> keeps up repeater with zero issues.  Just can't pick up receive!
> Any help suggestions appreciated
> 73 WW2MI
>
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org