[arm-allstar] Node to node connexion problem

[James R. Pilgram]

I experienced something similar last night on a node on our system. Traffic from the node to the system was working but when trying to talk from the system to the node was silent.  A disconnect and reconnect fixed the problem.  I should add that this node uses Exceed satellite and it may be just coincidence.  Doug, this is the node that you helped us get working through Exceed. 

Jim NH6HI 
Hawaii Mainland Allstar Network 


  Original Message  
From: arm-allstar at hamvoip.org
Sent: March 13, 2018 3:59 AM
To: arm-allstar at hamvoip.org
Reply-to: arm-allstar at hamvoip.org
Cc: ve2dbe at yahoo.ca
Subject: [arm-allstar] Node to node connexion problem

I am new to this forum We use many repeaters controlled with a RPI3 and Rim Lite
RPi2-3 Version 1.5rc4-16 Allstar - March 10, 2018 - KB4FXC, WA3DSP
Recently we observed a strange behavior:We have many locations where a repeater (allstar node) is connected to a transceiver (local node).The repeater is normally connected to the network via the RF link (We use the Internet only as a backup)Once in a while, users complain they do not ear anything from the network.I use IaxRpt and observe that there is no communications between the two nodes.However, the cli rpt nodes command show that the nodes are connected.If I disconnect and reconnect the nodes, everything is ok.I tested both ilink 3 and ilink 13, same problem.Has anybody noticed that behavior?
Roger Coudewww.ve2dbe.com
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org