[arm-allstar] Courtesy Tone Mapping

[David McGough]

Bill,

You need these statements in your rpt.conf node stanza:

linkunkeyct = by_node_number,ct8
node40000=ct12


Note that the ct8 is the default to use.

73, David KB4FXC


On Sat, 23 Jun 2018, "William Freeman via arm-allstar" wrote:

> Good afternoon, all. I am confused by this direction: "

*To complete the mapping you need to assign a specific node number or
numbers to a corresponding tone definition. Here is an example: *

*node40000=ct12 *

*ct12 does not exist in the current definition so it must be defined down
in the telemetry stanza of rpt.conf. Here is an example of defining a Morse
CW “K” as the courtesy tone for node 40000 *

*ct12=|iK *

*multiple node definitions can be made either pointing at the same or
different courtesy tones."*

Does the definition, in the example above node40000=ct12, go underneath the
telemetry section where the actual courtesy tones are dictated in terms of
pitch and rhythm, or somewhere else?


Thanks

bill n4njj

-- 
William Freeman
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org