[arm-allstar] PL Tone

[Doug Crompton]

I assume you mean using a decoded PL tone in lieu of a COS signal for
indication of RX?  If this is the case then you would need to use  usbradio
which is there but just not supported or generally recommended in the
hamvoip code. The config fiel is in /etc/asterisk/usbradio.xxx - this file
would need to be configured for your radio and the rxchannel line changed
in rpt.conf.

There are always ways around this however using hardware like a stand-alone
PL decoder driving COS which for now might be a better choice if I am
understanding your need.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Mon, Jul 16, 2018 at 8:28 PM, "David via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

>
> I have not had to use, in a long time, PL Tone control via Allstar node,
> but ran into a repeater that does not do it in remote mode.
> Where is rxctcssdefault located or its replacement.
> Thanks David
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20180716/aa12306d/attachment.html>