[arm-allstar] TX lockup

[Stanley Stanukinos]

Frank, disconnect the URI from the radio. Then connect a voltmeter or use a scope. Look at the radio COR lead level without a signal present and then with a valid signal present. What levels are you seeing in both cases. 

Stan

Sent from my iPhone

> On Feb 7, 2018, at 6:13 PM, Frank via arm-allstar <arm-allstar at hamvoip.org> wrote:
> 
> To the group,
> I have just put together my first Uri / Pi repeater controller using the Ham VoIP program.
> The issue I am having is I am getting a constant TX on my Uri no matter what settings I change or adjust.
> When I transmit on a radio, the system stops transmitting telling me I have a reversed COR setting somewhere but I cannot find it in either the Uri or Pi setup menus. All setting show lo as they should. I have tried to switch setting in both menus to hi but this makes no change.
> I have spoken with other users in my area and this issue has them stumped also.
> Any help will be wonderful. My node number is 47403.
> Please feel free to contact me via any of the below listings.
> 73
> Frank
>  
> Frank Cataldo, N2DKI
> 225 W. Basic Road
> Henderson, NV 89015
> 702-641-6555 home
> 702-561-8555 cell
> www.n2dki.com
>  
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20180207/23ee3440/attachment.html>