[arm-allstar] Setting time on new node

[Bryan St Clair]

I see you are registered but was not able to connect to you.  Could be you
don't have the port open for inbound connections.

What does asterisk say when you attempt a connection?

On Mon, Dec 24, 2018 at 9:49 PM "Ed Harwood via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hello to the group,
> I normally research and try to find the answer before I ask, but I need to
> ask the group about this one.
> I setup node 44043 tonight and went through the whole setup and it looks
> fine. However, the time and date on the Supermon is wrong. Also, the
> current weather conditions will not show up either. The node will not
> connect to anything and I would like to figure out what is going on. Seems
> like the time should update after a reboot.
> Thank you in advance for any suggestions.
> Ed W5CVE
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>


-- 
Bryan
K6CBR
bryan at k6cbr.us
Allstar Base: 43918, 43991
Allstar Hubs: 43919, 47036, 47061(Testing)