[arm-allstar] WiFi RPI3BP problem

[zvi.serlin at gmail.com]

Doug,

A complete fresh 1.5 download and installation produced the same results.

Ifconfig showing seperate ips and mac addresses for eth0 and wlan0 but
putty will not connect to ip:222 through wlan0.

A quick test out with ping showed that the wlan0 did not appear to be 
working
but was ok with the wired eth0. Beginning to look like a grade B item from 
China
wrapped up in an RS components box.

Regards

Zvi

-----Original Message----- 
From: "Doug Crompton via ARM-allstar"
Sent: Tuesday, December 4, 2018 5:10 PM
To: ARM Allstar
Cc: Doug Crompton
Subject: Re: [arm-allstar] WiFi RPI3BP problem

Zvi,

  You did not say what image you were using for the Pi. Are you using V1.5
downloaded and updated from hamvoip.org? In that case you will use the menu
to setup WIFI for the Pi 3/3B+ and scan for SSID and enter passphrase.
There is nothing you need to load or setup for WIFI other than this.

The Pi 2 has no built-in WIFI. Our WIFI support requires at least a Pi 3
with internal WIFI. The Ethernet and the WIFI on the Pi 3 have different
mac addresses so they will issue different IP addresses when using DHCP.
The Pi 3B+ also has 5 GHz WIFI.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Tue, Dec 4, 2018 at 9:35 AM "zvi.serlin--- via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Hi,
>
> A major problem with sea air and humidity lead to the demise of a 10A
> power module (copper track dissolved) and
> failure of the USB ports on my RPI. Eventually the PSU was repaired and a
> RPI3BP (PI3 Mod B) arrived, I plugged in my original
> SD card and proceeded to check connections. Wired worked fine, wifi did
> not, so burned a new SD card and started again with
> the same results. My first assumption was that I had received a faulty RPI
> so I inserted an SD card for a KODI streamer and tried again.
> This time the wifi connection worked perfectly and I was able to watch
> streamed video. So I know the wifi port works.
>
> Setting up the RPI again for Allstar ipconfig shows that wlan0 has picked
> up an ip address and scanning the router ports showed
> that the ip was there as well. In the meantime I am running allstar on an
> older RPI32 which works fine. Any ideas as to the
> possible cause of the problem?
>
> Many thanks
>
> Zvi Serlin
> 4X1ZS
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
_______________________________________________

ARM-allstar mailing list
ARM-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org