[arm-allstar] Node locks up RX-keyed

[Doug Crompton]

John,

  That is a hard one to troubleshoot. From what you are saying Allstar was
in fact telling it to key based on the simpleusb-tune-menu view
indications. A couple of questions -

Does this node have a good Internet connection? Is there any high power RF
nearby? Is there any possibility that it could be being keyed by someone
you are connected to? Does it happen when connected to other places? *Is it
possible to substitute another Pi and/or URI? Also you could try another SD
card as it is possible there could be some corruption there. Are you using
the latest updates?*




*73 DougWA3DSPhttp://www.crompton.com/hamradio
<http://www.crompton.com/hamradio> *

On Wed, Aug 22, 2018 at 10:03 AM, "w7jca via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

>                 Good morning,
>
>
>
> I have a node that has been operating for a few weeks now. Every so often I
> would get complaints that the node is sending a dead carrier with no audio.
> I could never find out what was going on. It would work ok for a day or two
> but then I would get a complaint about this. I monitored the node last
> night
> and finally seen it happened. I was connected to the WIN System for about
> 20
> mins and then 2 guys were having a QSO and all of a sudden my node keyed up
> and stayed keyed. It said "Node 48467 RX-Keyed" (my node is 48467) and
> looking at the node the COS (composite) keyed, COS (input) keyed, all the
> others said cleared. I grabbed my HT and pushed the PTT and then everything
> cleared and went back to normal. I am at a loss of what is going on.
>
>
>
> My setup is as follows. I have a raspberry Pi 3 connected to a URI
> connected
> to a Motorola CDM 1550. This is setup as simplex mode that connects RF to
> my
> repeater which is a Yaesu DR-2x. The wires-x is turned off. I shutdown the
> digital side a few weeks ago because when I started getting the complaints,
> I thought the digital side was causing this. I have PL`s set on both TX &
> RX
> on the repeater as well as the node radio. When I actually saw the node
> lock
> up there was no transmission from the repeater or the node radio.
>
>
>
> Any thoughts?
>
>
>
> Thank you
>
>
>
> John, W7JCA
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>