[arm-allstar] BCD Control

[Doug Crompton]

Eric,

I assume you are using the bcd_control_usb_fob.sh in the current
distribution of V1.5? There is no bcd_control.sh???

You need to define the GPIO commands in each stanza in simpleusb.conf - it
basically would be the same in each stanza. The script sends the command to
the defined node and unless there is a bug in cop,61 it should work. Do you
have it defined in both stanzas in simpleusb.conf? I have not tested with
multiple nodes on one server but it should work.

If you are using the Pi version then this would not work. You would have to
modify the code to use different GPIO ports for each node. Which actual
script are you using?


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*






On Tue, Apr 10, 2018 at 10:32 AM, "Eric Harrison via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I have started to use the bcd_control_pi.sh script and have notice no
> mater what node number I attache to the endof the command the ptt and voice
> are sent to $NODE1. I have two nodes configured on one pi and have
> verifiedboth node are functioning correctly. Running
> /usr/local/sbin/sayip.sh 42408 sends it to 42408 and
> /usr/local/sbin/sayip.sh 42409  sends it to 42409.
> If is issue the cmd.,  /usr/local/sbin/bcd.control.sh 1 42408, it sends
> the ch.1 command to 42408. If I issue the cmd., /usr/local/sbin/bcd.
> control.sh 1 42409, it still sends the ch.1 command to 42408.
>
> Guessing a bug or am I missing something in setup?
>
>  Eric (N7JYS) Marshall's Communications
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org