[arm-allstar] Bridgecom repeaters and Allstar

[Dave Miller]

And it has been working nicely for over a year.  Thanks Lee.  
And if anyone is wondering the interface boards are available;-)
Dave
VE7HR/VE7PKE

Sent from my iPhone

> On May 7, 2017, at 9:34 PM, Lee Woldanski via arm-allstar <arm-allstar at hamvoip.org> wrote:
> 
> Yes, have done it on the BCR-220.
> 
> Stuffed the Pi inside... http://www.bcfmca.bc.ca/rpt220.php
> 
> Note that I found the TX very sensitive to noise and hum... needed to add
> some extra grounding, even though I was using shielded cable.
> 
> Also, beware if you want to TX CTCSS and have CSQ RX... that is
> (apparently) a very tricky configuration to get working... pulled out lots
> of hair figuring out how (and even then, I'm not sure why it is currently
> working, since it shouldn't the way it is configured).
> 
> At the end of the day, it does work fine.
> 
> 
> Lee
> 
> On Sun, May 7, 2017 at 4:32 PM, "Charles L. Cotton via arm-allstar" <
> arm-allstar at hamvoip.org> wrote:
> 
>> Does anyone have information on using Allstar as a controller for a
>> Bridgecom repeater? '
>> 
>> 
>> 
>> Thanks,
>> 
>> Chas.
>> 
>> _______________________________________________
>> 
>> arm-allstar mailing list
>> arm-allstar at hamvoip.org
>> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>> 
>> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>> 
> 
> 
> 
> -- 
> Lee Woldanski, AScT
> VE7FET
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org