[arm-allstar] Setting up voting, I'm missing something.

[Michael Hebert]

Chuck,

I am assuming that you want to RX from all 3 sites and vote? Each site will
need an RTCM and a 1 PPS clock for the timing. I used the Garmin GPS 18x
LVC

In the rpt.conf, you will need to define the rxchannel=Voter/node number

Make sure that the master can ping the remote sites.

Michael KD5DFB

On Mon, Jun 12, 2017 at 8:39 PM, "Chuck Kimball via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I'm setting up a voting system for our local club and have most the parts
> here on the bench.
>
> I've got 2 of the RTCM units setup, and have configured a Raspberry Pi 3
> with the 1.5 image.
> The Pi is equiped with a Repeater Builder RIM Lite that will interface
> with an existing controller.
>
> I've created a voter.conf file  (below).
> In modules.conf the line for noload voter.conf is commented out.
>
> I see the RTCM connect and then  ERROR! Host response timeout, and Host
> connection lost.
>
> Everything is running on the local network currently.
> Pi/Server is 192.168.0.200
> Repeater is 192.168.0.201
> Receiver is 192.168.0.202
>
> I also tried setting up the 2nd node as pseudo node on the server with the
> same node number as the voter.conf (1100)
>
> I suspect there is a step to make the voting work that I've missed or not
> discovered in the documentation that I've been able to find.
>
> Any suggestions on where I should go from here?
>
> Thanks
> Chuck Kimball  n0nhj
> Glenwood Springs, CO
>
>
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>