[arm-allstar] How to remove repeater ID from link

[David McGough]

Tom,

As I recall, even if you can get the GR1225 programmed to selectively
enable or disable transmitted PL tone based on input signaling, the
CAT-300 controller has no way to selectively generate an output signal,
based on when it generates a CW ID.

So, as I think you are suggesting, you would have to "loop back" the PL 
decode from the GR1225 directly to the PL encode enable on the GR1225. You 
may end up with the beginning of words getting chopped off with this 
method, particularly if your CAT-300 includes a digital delay board.

Another possible solution might be to use the app_rpt notch filter feature 
to notch out the CW ID, leaving a few seconds of dead air...Getting this 
setup is tricky and may not work at all...You will need to know the exact 
frequency of the CW ID.

73, David KB4FXC



On Sat, 22 Jul 2017, "Doug Crompton via arm-allstar" wrote:

> Tom,
> 
>  First of all I am not familiar with this repeater but I believe that most
> Motorola
>  products allow you to strip PL on ID. That is have no PL during the ID
> period. Thus your remote node would squelch on ID using just the one PL
> tone. How this is achieved on your particular radio you would have to
> research. I suspect it is done in programming. See this -
> 
> 
> https://forums.radioreference.com/kenwood-ef-johnson-forum/355390-cw-id-strip-tk-8180-repeater.html
> 
> and Google  "GR1225 strip PL on ID"
> 
> 
> *73 Doug*
> 
> *WA3DSP*
> 
> *http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*
> 
> 
> On Fri, Jul 21, 2017 at 5:56 PM, "Tom Eaton via arm-allstar" <
> arm-allstar at hamvoip.org> wrote:
> 
> > I have a GR1225 repeater that has a Cat-300 controller, at the node
> > location I have a HT hooked to the node, I need to remove repeater ID so it
> > does not go to node.
> > I found where you can put a 2nd encoder on repeater at pin 5 on repeater
> > with differant tone and it will only have 2nd tone when there is a cos line
> > from repeater, I have tried this but tone in on pin5 no tone on TX.
> >
> > Can someone help with my problem
> >
> > Thanks
> > Tom
> > KC4CBQ
> > _______________________________________________
> >
> > arm-allstar mailing list
> > arm-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3 web page - http://hamvoip.org
> >
> >
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>