[arm-allstar] Pi 3 Allstar

[Dana Smith]

Thanxs Bryan for getting back to me.
I tried that command and its comes back as "no command".I am using a keyboard and monitor connected to the pi3.
Currently I want to monitor until I can makeup a cable for the radio.
Thanxs
DJS 

    On Tuesday, January 10, 2017 12:20 PM, Bryan St Clair via arm-allstar <arm-allstar at hamvoip.org> wrote:
 

 You can dial one via the SSH connection or with your radio. Short answer:

Via radio is *3xxx (replace the xxx with the node number you want.) For
WINS the node is 2560.

Via SSH on the first prompt you can enter "asterisk -rx "rtp fun yyyyy
*3xxx" " (remove the outside quotes and make the yyyyy your node number and
the xxx the node you want to connect to.

In both examples change the *3 to *1 and it will disconnect that connection
for you.

On Jan 10, 2017 7:35 AM, Dana Smith via arm-allstar <arm-allstar at hamvoip.org>
wrote:

> Greetings all;I just installed the allstar os from Crompton's website and
> everything went smoothly.However I am not sure how to link to other
> nodes.Can anyone point me in the right direction?
> I log into root but not sure where to go from there.I tried the dial up a
> node from that point but I think I am not in the right place to do so.
> Thanxs and 73
> Dana W2FXR
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3 web page - http://hamvoip.org