[arm-allstar] New node, audio problem

[Doug Crompton]

Yes, you could use the B output as well as A, so give it a try.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Tue, Feb 28, 2017 at 12:57 AM, "Justin Reed via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> On 2/27/2017 11:49 PM, "Doug Crompton via arm-allstar" wrote:
>
>> Justin,
>>
>>   The same audio comes out on both channels. We normally use A but if you
>> hooked it up to B that is OK you just have to set the levels with B in
>> simpleusb-tune-menu. Pin 22 on the URI is correct for Channel A. You have
>> set the A level in simpleusb-tune-menu?  Perhaps try switching in another
>> FOB to see if that is the problem.
>>
> I have the output of A turned up to 700 and there is no output. B is still
> at the default 500. I'm wondering if I moved to pin 23 if maybe the audio
> would work there. The URI schematic looks like there are no shared
> components after the chip so maybe it's worth a shot. I was hoping my
> second install would be easier than the first ;)
>
> I have another URI on the way, should be here this week. Hopefully it's as
> simple as that.
> Thanks,
> Justin
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>
>