[arm-allstar] No audio to Broadcastify using ezstream

[Doug Crompton]

I suspect the ezstream code is somehow corrupted. You might try just
running ezstream without any parameters and see what happens. I don't think
anything in the xml file would cause that though. You obviously have to
compile this code for the Pi you can't just copy the package from some
other OS.

ezsstream is not a repository package. So try downloading and installing it
again. Just google ezstream. It does work so your situation is unique.
Instructions are in the howto on the hamvoip.org web page.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Sat, Dec 23, 2017 at 2:22 PM, "Justin Reed via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> The timing of this particular email thread is good because I have a sudden
> new problem with one of my nodes failing to start the stream.
> When I run
>
> ezstream -qvc /etc/ezstream.xml
>
> I get:
>
> Segmentation fault (core dumped)
>
> And if I try to boot the node with the outstreamcmd line in place, it will
> hang and cause the httpd service to fail also.
>
> Any ideas what is causing a segmentation fault?
> Justin
> NV8Q
>
>
> On 12/22/2017 11:30 AM, "Doug Crompton via arm-allstar" wrote:
>
>> Chris,
>>
>>   Typo in previous message should be -
>>
>> ezstream -qvc /etc/ezstream.xml
>>
>> This will not actually do anything but it will process the config file and
>> tell you if there are any errors. Also when you do connect you will get an
>> email that you are connected and also when you go offline for some reason.
>>
>>
>> *73 Doug*
>>
>> *WA3DSP*
>>
>>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>