[arm-allstar] remote receiver site uhf vhf 2 nodes transmitter site uhf vhf 2 nodes

[Doug Crompton]

Stan,

  Again, it is very hard to troubleshoot if you don't give more
information. Are you having problems connecting the second node out or
connecting into it? What error messages do you get? Does it just not do
anything when you attempt a connect or does it tell you connection failed?
If you manually setup the second node it is likely you did not get
something right in the setup. This is something I could probably fix in a
few minutes if I was to log into your system. I would be glad to do that if
you send me the information in a private email - node numbers, login
password, ssh port. Also the port must be forwarded in your router so I can
log in remotely.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*


On Tue, Dec 5, 2017 at 10:00 PM, "stan siems via arm-allstar" <
arm-allstar at hamvoip.org> wrote:

> I have a remote receiver site having a uhf and vhf repeater site I am
> using two uri's and a raspi3 transmitter end the same setup my first node
> works fine I can not get the second node to connect every thing has been
> set up correctly for the second node, Has any one done this before and had
> it work? What problems did you have?
>
> --
> Thanks Stan Siems WB0EMJ The difficult we do right away the impossible
> just takes a little longer and the words it can't be done should never be
> spoken!
>
> _______________________________________________
>
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3 web page - http://hamvoip.org
>