[arm-allstar] Two node system

[Roselito de los Reyes]

Hi Robert,

Make sure an entry is made on the rpt.conf for each of the node. This is done under the [nodes] section
Node1 = radio at 127.0.0.1/node1,NONE
Node2 = radio at 127.0.0.1/node2,NONE
Save the file and Restart asterisk



Best regards,

Roselito De Los Reyes


> On May 9, 2016, at 5:14 PM, Robert Newberry via arm-allstar <arm-allstar at hamvoip.org> wrote:
> 
> I'm working on setting up a two node system (two nodes on one raspberry pi 2) I am running the hamvoip image. I followed these instructions 
> http://ohnosec.org/drupal/node/49
> 
> I can not connect the two nodes to each other. I went to allstarlink.org and made sure to use the same port.
> 
> Is there any trouble shooting suggestions to see if I can figure out why they will not connect? I've also left the node online for a while to make sure it gets the database.
> 
> In the CLI I says congestion and will not connect.
> 
> N1XBM
> Apparare Scientor
> Paratus Communicare
> Allstar Node # 27086, 41540, 41812, 42086, 42658, 42657
> www.radioguysrepeaternetwork.com
> 
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2 web page - http://hamvoip.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20160509/32fa2858/attachment.html>
-------------- next part --------------
_______________________________________________

arm-allstar mailing list
arm-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2 web page - http://hamvoip.org