[arm-allstar] irlp on rasberry pi 3

[Bob Pyke]

http://www.crompton.com/hamradio/BeagleBoneBlackAllstar/wireless_howto.pdf

IRLP runs on Debian in their configuration, with their board, and they configure your node.

arm-allstar runs on arch-linux, you have control of setting up your node, and do not require their custom board.

In other words, the two systems are not compatible in any way shape or form.

I've helped folks set up IRLP, and setup several allstar systems. Allstar is friendlier, and the two do not connect, and should not.

Bob
k6ecm
73

Sent from iPad


> On Jul 8, 2016, at 9:26 PM, Denzel Holmes via arm-allstar <arm-allstar at hamvoip.org> wrote:
> 
> I'm looking to setup irlp on my rasberry pi 3. I've downloaded and installed the RPi2-3 image onto my sd card and ran through the first time setup. Now i need to install the wireless but the link to the wireless config on the hamvoip website no longer works.
> Is this project still active? If so where do i get the wireless config package so i can install wireless?
> Also will i need to purchase the irlp board and attach it to my rasberry pi to use this as an irlp?
> 
> Locked in the mind lies the power to do anything. Attitude is the key. Keep it positive!
> _______________________________________________
> 
> arm-allstar mailing list
> arm-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2 web page - http://hamvoip.org