[arm-allstar] remote command mode hangup issue

[Neil k8it]

I just ran into a new issue with a RPI in remote control mode. first some facts
Primary node is in duplex=2
simpleusb channel driver is set to duplex=1
Second node is a half duplex link so
duplex=1
simpleusb channel driver duplex=0

when the second node is placed in remote command mode the primary node which is full duplex stays keyed up regardless of if the secondary node HALF DUPLEX is keyed up or not.
If someone forgets to take the secondary node out of remote control mode by sending a # dtmf digit
the main node times out
if somebody keys the main repeater, it keys up again , times out and the cycle goes on.

I would prefer that
1. the main node unkeys when it does not have any more to transmit
2 when and if the main node timesout that the remote command mode is terminated

Any thoughts?

Thanks
73 Neil Sablatzky  K8IT
Allstar Node 41838 KITLINK
Allstar Node 42087 KITLINK HUB
IRLP Node exp0068
Echolink K8IT-L
WIRES-X K8IT 11479 Room 21479


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.hamvoip.org/pipermail/arm-allstar/attachments/20151130/7035918e/attachment.html>