[arm-allstar] Kenwood TM-V71A Settings

[Ron Wenig]

Hi Everyone,

If anyone is using a Kenwood TM-V71A radio for their node I would like 
to compare menu 520, the SQC Output Setting to make sure that mine is 
set correctly. I am using the rear 6 pin din data connector in the back 
of the radio. The SQC pin is connected to the COR -DET pin of the URIx 
connector.

Here are the selections for menu 520.

Set the SQC output activation method to one of the following:
• OFF: SQC output remains inactive.
• BUSY: When a signal is received on the data band, the SQC output 
becomes active.
• SQL: While CTCSS/DCS is ON and a matching signal is received, the SQC 
output
becomes active. While CTCSS/DCS is OFF, the SQC output becomes active when
a busy signal is received.
• TX: While transmitting, the SQC output becomes active.
• BUSY.TX: When the conditions of BUSY and TX (above) are met, the SQC 
output
becomes active.
• SQL.TX: When the conditions of SQL and TX (above) are met, the SQC output
becomes active.

Everything that I've read about this radio and Allstar is the setting 
should be SQL and that is where it's set. Also, I have the radio control 
knob set fully counter clockwise, set to unscquelch. My tone and ctcss 
are both set.

73, Ron NY3J