[arm-allstar] Propagate DTMF

[Chris Z]

I do something like this.
I have an RC850 on my 220 repeater.
It has remote links.
I have a radio link from allstar node to repeater remote link.
The only way I found is from my local node put the remote node in command
mode with the *4.
Then I have macros to dial commands that send tones to the remote link.
I can turn both remote links on and off in RX or TX and even put them in
x-band mode.
I can change frequency memories on both remote links.
I can send controller commands to the repeater when the remote link is set
in sysop mode.
I found that liberal use of the pause is helpful especially in front of the
first tone.


-----Original Message-----
From: ARM-allstar <arm-allstar-bounces at hamvoip.org> On Behalf Of Eric 4Z1UG
via ARM-allstar
Sent: Saturday, February 10, 2024 12:04 PM
To: arm-allstar at hamvoip.org
Cc: Eric 4Z1UG <eric at qsotoday.com>
Subject: [arm-allstar] Propagate DTMF

I want to connect Allstar to a legacy repeater controller by propagating
DTMF.  I was able to search the list archive and found that there use to be
commands in the simple-usb.conf file where you could enable or disable DTMF
propagation.

What I really want is to:
use a macro to connect to my legacy repeater controller.
It would:
connect to distant node *3XXXXXX
Still mute all DTMF tones on the local repeat loop
Propagate all DTMF tones sent to the link

Is this possible?

73,

Eric, 4Z1UG
_______________________________________________

ARM-allstar mailing list
ARM-allstar at hamvoip.org
http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar

Visit the BBB and RPi2/3/4 web page - http://hamvoip.org