[arm-allstar] Start4.elf not compatible pi4 1g

[N4UPC]

Ryan,

It is probably the 1.5 or later board version. For it to boot HamVoip, do the following:

1) On an unused card, burn the latest Raspberry Pi OS to it and boot it up on your new Ras Pi 4B. You can either sftp or use a USB thumb drive to copy two files in the /boot directory: start4.elf and fixup4.dat

2) Once you have these files, shut down the Ras Pi 4B board and remove the Ras Pi OS card.

3) Boot your HamVoip card on your Ras Pi 3B board, go into the /boot directory and rename the existing start4.elf to orig-start4.elf and the fixup4.dat to orig-fixup4.dat. Copy the the two files from step 1 to the /boot directory.

4) Shut down the Ras Pi 3B, move the card to your new Ras Pi 4B and it should boot up.

I can also email you the files if it would be better. Just let me know directly.

73,
Scott
N4UPC
HSH #: 11648

On Mon, May 9, 2022 at 10:09, ryanro77--- via ARM-allstar <arm-allstar at hamvoip.org> wrote:

> Just received a new pi4 1g and when I tried to boot Hamvoip allstar I was given the Start4.elf not compatible newer software required for this board message. I have read this being a resolved issue with the 8g pi4 but I haven’t seen any discussion or solutions for this on a new pi4 1g. Any help would be very appreciated.
>
> Ryan R.
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org