[arm-allstar] Command To Shut Down Node

[David McGough]

Power cycle!



On Wed, 22 Jun 2022, "Anthony (N2KI) via ARM-allstar" wrote:

> And after clean shut down, is there a way to DTMF a boot up?  Or do I have
> to power cycle the unity?  Thanks!
> 
> Regards,
> 
> Anthony (N2KI)
> 
> 
> 
> 
> 
> 
> 
> 
> 
> On Tue, Jun 21, 2022 at 10:35 PM "Ken Rugaber via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
> 
> > Yes!
> >
> > You may need to edit your rpt.conf file to enable.
> >
> > There are three commands B1, B3 and B6 probably commented out.
> >
> > B1 I believe shuts down
> > B3 I believe restarts Asterisk
> > B6 I believe reboots unit.
> >
> > I am doing this from memory from my cell.
> >
> > Ken KC9QV
> >
> > On Tue, Jun 21, 2022, 20:49 "Anthony (N2KI) via ARM-allstar" <
> > arm-allstar at hamvoip.org> wrote:
> >
> > > Hi,
> > >
> > > Is there a dtmf command to power down the node cleanly rather than just
> > > pulling the power cable?
> > >
> > > Thanks
> > >
> > > Anthony N2KI
> > > _______________________________________________
> > >
> > > ARM-allstar mailing list
> > > ARM-allstar at hamvoip.org
> > > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> > >
> > > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> > >
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> >
> _______________________________________________
> 
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> 
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>