[arm-allstar] Asterisk very slow [correction]

[Steve Agee]

*Correction:

That should have read "write your changes to the 
/etc/asterisk/simpleusb.conf file"

N5ZUA
*
On 3/14/2021 10:47 AM, "Alan Bartkowiak via ARM-allstar" wrote:
> I have a new build using hamvoip on a Pi4b with a URIxB.  Also I need to
> mention that I am very new to
> Allstarlink.
> The problem I'm having is:
> When asterisk cli is started, I enter a *2 <node#>. The DTMF tones are
> decoded as they should and get the ulaw message
> that it is being acted on. Looking at the Allstarlink portal shows that I
> am connected however there is no audio through my
> simplex radio. I do see "hang-up" whenever anyone unkeys from the node that
> I am connected to. After about 5 minutes
> give or take, I will get the announcement node 53735 connected to node
> xxxxx and the audio will now come through. After that
> I will get the announcement "53735 timeout" and DTMF tones are no longer
> acted upon although they are decoded properly.
> I am still shown as being connected to the node and am still getting audio.
> The only way to disconnect is to restart Asterisk.
> If I enter a *3 <node #> to be in transceiver mode, There is a dead carrier
> on the connected node and the only way out of it is to restart asterisk.
> Didn't want to tie up the node for 5 minutes to see what happens when
> asterisk decides to act.
>
> Thank you in advance for any assistance to resolve this.
> Alan Bartkowiak N2ZVN
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org