[arm-allstar] Two Public Nodes on One RaspPi

[Michael Webb]

Page 10 of the file linked below.
You don't have to use 1998 or 1999, you can copy the info from you current
setup. It just depends on what to do.

https://hamvoip.org/howto/config-setup.pdf

On Tue, Jan 19, 2021, 5:11 PM "Kevin Davis via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> You will need to change all references to your old node # of 49485 to
> 494850 as well.
>
> On Tue, Jan 19, 2021 at 1:16 PM "Kyle Krieg via ARM-allstar" <
> arm-allstar at hamvoip.org> wrote:
>
> > I expanded my node 494850 and added a note 494851.  I'd like to run this
> > public node on the same hardware.
> >
> > I haven't done a lot of AllStar administration lately because the node
> has
> > just run without any issues.
> >
> > I'm assuming to add this node, all I would need to do is replace node
> 1999
> > stanza information with 494851 or just create a new stanza?  Just
> wondering
> > if there is an automated or script that would load all the info?  The new
> > node can communicate on the same port?
> >
> > Thanks
> > Kyle
> > _______________________________________________
> >
> > ARM-allstar mailing list
> > ARM-allstar at hamvoip.org
> > http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
> >
> > Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
> >
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>