[arm-allstar] Node 50820

[Doug Crompton]

Ron,

 When connecting is successful you should get the connect message unless
you have telemdefault set to 0.  Permanent connects always show connected
courtesy tone because they are constantly retrying. You need to go into the
client and do the connect from there and observe the results. It is likely
the connect is not taking place as the other node might be not reachable.
Client messages will give you a clue.


*73 Doug*

*WA3DSP*

*http://www.crompton.com/hamradio <http://www.crompton.com/hamradio>*

On Fri, Mar 20, 2020 at 6:04 PM "Ron Gilson via ARM-allstar" <
arm-allstar at hamvoip.org> wrote:

> Node 50820 operates as a repeater controller very well.  The *80, *81, *82
> all work.  Node with a *73XXXXX command I receive the connect confirmation
> tones on the tail and the node shows on the All Star website.  The
> problem is the node is not connected even though the tones on the tail
> indicates you are connected ???  Any idea where to look for trouble
> shooting this problem.  Thanks.
> Ron
> _______________________________________________
>
> ARM-allstar mailing list
> ARM-allstar at hamvoip.org
> http://lists.hamvoip.org/cgi-bin/mailman/listinfo/arm-allstar
>
> Visit the BBB and RPi2/3/4 web page - http://hamvoip.org
>